Like all parts of an engine, transmission cooling lines can wear out. If they break or develop a leak, you will lose transmission fluid, leaving your car vulnerable. Thankfully this is a fairly simple fix, and most transmission line repairs cost between $100 and $500 dollars.
How long does it take to replace transmission cooler lines?
How Long Does It Take to Replace Transmission Cooling Lines? Getting the cooling line in your transmission repaired can be a time-consuming job. Transmission repairs often take a day or two at the mechanic depending on how extensive they are.
How much does it cost to replace a transmission cooling line?
You will pay somewhere between $100 and $450 for a transmission cooler line replacement. The labor should be between $60 and $300, while parts can cost you anywhere from $40-$160.
Can you remove transmission cooler lines?
To use the wrench, slide the open end of the wrench over the cooler line, then slide the wrench down the line until it reaches the nut used to secure the line to the transmission. Use the wrench to loosen the nut located at the end of each line, then pull the line away from the transmission to remove it.
How long does it take to fix transmission lines?
Transmission repair can take a full day but it will take at least 3 to 4 days to rebuild a transmission.
What happens if you reverse transmission lines?
If you had it reversed, the pump would be trying topush fluid through the bottom of the cooler, up through the cooler, out the top into the bottom of the rad, and up through the rad to the top.
How much does it cost to fix a transmission line leak?
Typical Cost to Fix a Transmission Fluid Leak
If you have fluid leaking from your transmission, the typical cost to repair the leak (without taking off the transmission) is between $150 and $200. For this amount, you will get a replacement of the pan bolts, drain plugs, seals, gasket, fluid lines.
What causes transmission cooler lines leak?
The most common transmission cooler failures are due to either a leak in the body of the cooler itself, or a clogged line caused by something flowing through the system. This most likely is from the transmission itself.
Can I use rubber hose for transmission cooler lines?
You can use rubber hose, but make sure it’s transmission cooler line rated. The pressure is quite low (12-15 psi). Double clamp it or use FI type clamps instead of the worm-drive style.
What is transmission cooler line?
Your transmission cooling lines, often just called the transmission lines, are the lines that connect your transmission to the radiator in your car. … They’re made up of a system of rubber hoses and metal or composite aluminum tubes that allow for transmission fluid to flow through them at high temperatures.