How much does it cost to rebuild a GSR transmission?
a used good condition gsr or b16 tranny will run you $500-700. a rebuild is at least $1000.
How much does a GSR transmission weight?
weight without clutch and FW? about 80 lb.
How much fluid does a GSR transmission take?
yep right around 2 qts.
What is a YS1 transmission?
Re: Ys1 good and bads
Either way the YS1 transmission case allows you to swap gears, differentials or entire gearsets out for ones from any newer 92+ hydraulic B-series transmission, up to and including Type R parts.
What is a Y80 transmission?
The Y80 is a generation code used by honda. In fact, the Y80 was used in every B series chassis world wide from 1994 thru 1997 The Y80 also came in different configurations and had different gears ratios. Y80 USDM 94-97 Integra LS/RS/GS Special Edition. Y80 USDM 94-97 Integra GSR.
How heavy is a K24 engine?
A Honda K24 engine complete with starter, alternator and exhaust is just over 300lbs.
How heavy is a b16a2 engine?
The B16A weights in at 309 lb. so when compaired to the B18B at 350 lb and the B18C1 at 370 lb.
What does an LS motor weigh?
The engines weigh about 460 lbs. fully dressed with accessories and flexplate.
How many quarts does a b16 transmission take?
Here in the US it is about 3.5-3.9 Quarts.
How do I know what Honda transmission I have?
It is also on the Certification label attached to the driver’s doorjamb, and is stamped on the engine compartment bulkhead. The VIN is also provided in bar code on the Certification label. The Engine Number is stamped into the engine block. The Transmission Number is on a label on top of the transmission.