Are all Ford 302 engines the same?

Are there different 302 engines?

Be aware there are 2 types of 302 EFI motors; HO and non-HO. HO motors were used primarily in the Mustang from 87 to 95, but were also used in Lincoln mark 7’s LSC from 89 to 92 and in the 91-93 thunderbird. HO motors have better cylinder heads (E7TE casting), more aggresive cam (266 duration and .

Are all 302 distributors the same?

The distributor in the 351w is the same length as the 302 distributor, but the 351w does use a larger diameter oil pump drive shaft. The larger drive shaft will require the larger diameter distributor shaft. The shaft diameter of the 302 distributor is . 40”, while the 351w distributor is .

Are all 302 heads interchangeable?

Like the 289 heads mentioned earlier, all 302 heads are the same except for Thermactor provisions. There’s also a truck head (C9TE-C), which employs a 58.2-cc chamber for slightly higher compression. Ultimately all 302 heads were carryovers of the 289 head, making them all interchangeable.

Is 302 better than 351W?

So for equal money, a 351 will have more cubes, more low end torque, and a lower RPM peak. A 302 will have the same HP, but a slightly higher tq peak with lower tq numbers. In almost any situation, cubes are better. Unless you can make your goals cheaper with the super-cheap 302.

THIS IS IMPORTANT:  Is it good to buy electric car in India?

How much horsepower can a Ford 302 make?

Standard Ford 289 and 302 small-blocks were factory-rated between 200 and 230 hp. The vaunted 289 High-Performance engine was said to make 271 hp. Today, if a 302 Ford makes 360 hp on pump gas with a hydraulic cam, most experts consider it to be a pretty good motor-at least until Joe Sherman steps up to the plate.

How long will a Ford 302 last?

The 302 is a great engine, probably one of the best Ford has ever built. It’s impossible to say exactly how long an engine will last, but obviously it will last longer if it’s been taken care of. If it’s had proper maintenance and you do the same, it could easily go another 100K or even more.

When did Ford stop making the 302?

Meanwhile, the Boss 302 Mustang was removed from the model-year lineup, having ended its limited-edition run in 2013.

Will a 351 distributor fit a 302?

Registered. Windsor distributors can be interchanged between all engines from 221 cid to 5.0L. However, because of the taller deck height, a 351W distributor is longer, and will not fit a 302 block, nor will a 302 distributor fit a 351W.

Will a 351 Cleveland distributor fit a 351 Windsor?

yes it will fit IF YOU cut of the bottom of the shaft a 1/2 inch meaning the shaft on the gear…

How do I know what heads My 302 has?

Ford 302 Cylinder Head Identification

  1. Number Location. The casting number is located under the valve cover, in the middle of the cylinder head. …
  2. Number Decoding. The number within the code identifies the year of manufacture; a head with code C8ZZ-A would have been manufactured in 1968, and so forth. …
  3. Other Considerations.
THIS IS IMPORTANT:  Is Unreal Engine 4 completely free?

Are 302 and 351W heads the same?

The 351W heads are the exact same size as 302/289 heads, just have bigger valves and combustion chamber. 302 intake/exhaust manifolds will still fit fine.