The simplest most straightforward way to get rid of the check engine light is to drive it for a little bit, and the light will turn off by itself. Once you drove your car for a couple of days (e.g., usually three days), the check engine light should be gone.
Can you manually turn off check engine light?
You may also need to manually reset the light after making repairs if the code doesn’t clear automatically. The best way to reset a check engine light is to use a code scanner. However, if your vehicle was manufactured before 1996, you can simply disconnect the battery to reset the light.
Will AutoZone reset check engine light?
Does AutoZone Scan Check Engine Lights? AutoZone does. If your light is on, and you are wondering why, head down to your local AutoZone where one of our store associates can help diagnose the issue through our free Fix Finder service.
Why is my check engine light on but no codes?
If the check engine light is on, you’ve got a trouble code stored. … If your check engine light is on but no code, it’s your scan tool, not the vehicle. You’ve only got two choices at this point; buy a scan tool that can read enhanced as well as B, C and U codes, OR pay a shop to read the codes for you.
How far do you have to drive to reset the check engine light?
To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.
Can you clear codes to pass emissions?
To pass an OBD-II emissions test, a vehicle must:
If you clear the ‘Check Engine’ light, or reset the OBD-II monitors right before your emissions test, your vehicle typically will not pass because the catalyst and EVAP monitors need time to run. … If it’s not in a “ready” state, your vehicle will automatically fail.
Is it illegal to sell a car with the check engine light on?
But what about that check engine light? The reality is that most potential buyers are going to be wary of purchasing a car or truck with an illuminated dashboard warning light. And the truth is that it is illegal in most states and/or counties with “clean air” emissions standards to sell a car that won’t pass the test.
What does clearing fault codes do?
On clearing the codes with the “Erase Codes” function, the system status changes to “Not Ready”. … Take several individual trips until the system reads the status of all the components once more. “Several trips” means you shut off the engine and start another trip each time.
How do you tell if OBD codes have been cleared?
If the vehicle does not support the above datapoints you can use the smog check feature to check for indications of codes being recently cleared. When codes are cleared all vehicle emissions tests are reset and will display a status of ‘not complete’.