How do you check the power of a blower motor?
Check for power at the motor itself. Using a test light or a multimeter set on volts, unplug the blower motor. Keeping the black lead on a good ground, usually a bolt on the engine block, and the blower switch turned on, use the red lead to probe the plug that usually attaches to the blower motor.
How do I know if my blower motor is not working?
What Are Signs Your Blower Motor Needs to Be Replaced?
- Poor or Airflow from Air Vents. This will be the first and most obvious sign your blower motor has a problem. …
- No Airflow At All From Vents. …
- Skyrocketing Energy Bills. …
- Strange Noises When You Turn on the Heat. …
- Overheating Blower / Weird Smells.
How do you tell if it’s the blower motor or resistor is bad?
Symptoms of a bad heater blower motor resistor
- Fan does not work at all, so no air comes out of the vents.
- Fan only works on some speeds and not others.
- Fan only works on the highest speed.
- Fan runs all the time and can’t be controlled with the fan switch.
- You see smoke coming out of the vents.
Will a blower motor work without the resistor?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
Can a blower motor be repaired?
Blower Motor Replacement: When Good Parts Go Bad. … There are a number of things that can go wrong with your heating system, but if the air stops blowing altogether and the same is true on cold air settings, a blower motor replacement is likely in order. The good news is that it’s a fairly straight forward repair.
How many volts should a blower motor receive?
Typically it’s done by measuring the voltage at the blower motor connector when it’s turned on. If there is a voltage at the motor (at least 4-6 Volt at low speed and 12 Volt at high speed), but the motor doesn’t run, the motor is bad or jammed.
Why does the blower motor stopped working?
In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. … Start by checking the blower fuse and HVAC controller fuse.
What happens when blower motor relay goes bad?
If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.
How much does it cost to replace a blower motor resistor?
The average cost for a Blower Motor Resistor Replacement is between $108 and $137 but can vary from car to car.
How much does it cost to replace a blower motor?
Cost to Replace Central or Forced Air Blower Motor
Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.
How do you know if a resistor is bad?
How to Know If Resistors Are Good or Bad
- Turn off the power running through the circuit containing the resistor you need to test. …
- Look at the color bands around the barrels of the components for the code to determine resistor values. …
- Check resistor values with the color codes.
Can you test a blower motor resistor?
If you want to do a quick test of the blower resistor, you can check the resistance of each of the resistors with a multimeter as follows: set the tool to read ohms (a measurement of resistance) and connect one of its probes to the common output terminal of the resistor.