Is a Chevy 327 a good motor?

How much HP does a Chevy 327 have?

Rated at 375 hp, the fuel-injected 327 was a high-winding screamer, as satisfying to drive as any big-block. At the other end of the spectrum, the 327 was also offered at much more pedestrian power levels, as low as 210 hp (gross).

Is 327 a good motor?

Chevy 327 engines are some of the best ever produced. They’ve powered everything from boats, hot rods, sprint cars, pickups with campers, and drag race race cars. I was in awe, reading Hot Rod Magazine in the sixties, when they described getting 1 horsepower per cubic inch out of the 327.

What year did they stop making the 327 engine?

The final year for the 327 engine was 1969.

Can you stroke a 327?

Your 327 has a 4 inch bore, so yes, you could make it a 355 or a 383. (also a 302, for that matter). A 1965 327 has a small journal crank, that is a factory “forged” piece. Your engine builder is making a 355 or a 383 by changing the crankshaft to a longer stroke, and replacing the pistons to match.

Will 350 heads fit on a 327?

Bill, 350 heads will work on your 327. Avoid 305 heads like the plague, though. You will want to find some with similar size combustion chamber and valve size/port size in order to keep at least the same power output your 327 had when new.

THIS IS IMPORTANT:  Frequent question: Can oil pressure sensor damage an engine?

Did Chevrolet ever make a 327 4 bolt main?

No – GM never made a 4-bolt 327 for production use; many have been drilled and tapped for six extra splayed bolts with aftermarket main caps on the #2-3-4 journals by machine shops, but GM never made one.

Is the GM 5.3 a 327?

The 5.3L is not a 327 or even close to a 327.

How much HP can I get out of a 383 stroker?

The 383 stroker engines have been reported to achieve 330 horsepower with 410 foot-pounds of Torque, 395 horsepower with 410 foot-pounds of Torque and 395 horsepower with 410 foot-pounds of Torque.

Are 327 and 350 blocks the same?

Re: 327 block same as 350??

Yes, the first 327 was a small journal engine up until mid 67, when they made the big journal crank. The 307 and 350 were all big journal. Even the mains were smaller on the small journal engine, so the big journal crank will not fit in the small journal block.

Is a 400 small block better than a 350?

A small block 350 and a 400 have an identical block design. Most accessories will fit either engine. The major difference is found in the casting numbers and the way they are balanced. Most 350 cubic inch engines are internally balanced whereas the 400 engines are not.