Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.
What type of transmission fluid goes in a 2008 Acura TL?
FRAM Transmission Fluid – Full Synthetic Dexron VI Automatic Transmission Fluid 1 Gallon (Part No. F426-1G)
Does the Acura TL have a transmission filter?
Acura TL Transmission Filter (A/T)
How often should you change transmission fluid Acura TL?
If you regularly drive your vehicle under these conditions, have the transmission fluid changed at 60,000 miles (100,000 km), then every 30,000 miles (48,000 km). (For A/T only.) Independent of the Maintenance Minder information, replace the brake fluid every 3 years.
Which Acura TL has transmission problems?
The Acura TL transmission has had its share of problems throughout the years beginning with the 2002 model and going through to the 2012 model. In 2002, the Acura TL had a widespread defect within the transmission that meant complete transmission failure at around 148,000 miles.
How many quarts of transmission fluid does a Acura TL take?
2009 2010 2011 2012 2013 2014 Acura TL Transmission Fluid Capacity
|5-speed BK4A automatic transmission||Total Fill 7.7 litres (8.1 quarts)|
|6-speed MMGA automatic transmission||Total Fill 7.1 litres (7.5 quarts)|
|6-speed MMHA automatic transmission||Total Fill 8 litres (8.5 quarts)|
What kind of transmission fluid does a 2000 Acura TL take?
Acura TL USA Built 2000, Dexron III (G)/Mercon V Automatic Transmission Fluid, 1 Liter by Febi®. Oil Type: Dexron III (G)/Mercon V. Volume: 1 Liter.
How do you check the transmission fluid on a 2005 Acura TL?
How Do You Check Transmission Fluid?
- Turn your Acura on. You’ll want your engine warmed up, so you can best check the levels.
- Locate the transmission fluid dipstick. …
- Remove the dipstick and touch the fluid. …
- Get a rag and wipe off the dipstick. …
- Use a funnel to bring the level up to full.
How do you check the transmission fluid on a Acura TL?
The transmission fluid should be checked when the transmission is hot, which is typically after 20 minutes of driving. With the car on a level surface, remove the dipstick, wipe it clean and then reinsert it firmly. Remove the dipstick again and check the fluid level while holding the stick horizontally.