You will not damage the engine running at 3400-3600 rpm because the engine is designed to operate at that speed. The blade manufactures have determined that the maximum safe speed for the blade is having a tip speed of 19000 foot per minute.
Why do small engines run at 3600 rpm?
Sped up, the engines designed for 3600 would be more likely to tear themselves apart, yes. But one reasonable explanation is that 3600 is the RPM required for a conventional (sometimes called “contractor”) generator in the US (that’s 60 Hz AC). So any generator engine must run at 3600, regardless of the size.
How much horsepower is 160cc?
Power and Torque
Most 160cc Honda mower engines output around 5.5 horsepower.
How can I make my lawn mower more powerful?
How to Get More HP Out of a Lawn Mower Engine
- Remove the flywheel housing from the top of your engine. …
- Unscrew the bolt holding the governor flap next to the flywheel with the proper sized wrench. …
- Inspect the muffler. …
- Fill the gas tank on your mower with a high octane gas. …
- Maximize the air flow.
How do I know what RPM my snowblower is?
Lock down the lever that engages the impeller/auger. Note/mark the starting position of the auger and the engine pulley and count how many times the engine turns over for one full revolution of the auger.
How do you check lawn mower RPM with a multimeter?
A few wraps of wire around the spark plug cable may act as enough of an antenna to pickup the high voltage pulse emission from the spark wire and allow the multimeter to see the interference / emission as a stream of pulses that can be interpreted as RPM.
Why is my mower idling low?
A lawn mower’s engine continues to run at low speeds when idling, pulling just enough fuel and air into the carburetor to keep combustion going. If the mower doesn’t idle properly, it’s usually because of a loss of fuel or air in the carburetor at these low speeds.
Why does my lawn mower run sluggish?
Maintenance lapses become evident when the mower turns over slowly or begins to falter at start-up. The fault could be a dirty spark plug, air filter or carburetor, or it could be related to the quality of the gasoline used. Slow starting can also be the result of a failure to clean the blades.
Why is my lawn mower idling high?
A carburetor that’s incorrectly adjusted is a common cause of poor engine idling that results in hunting and surging. Fortunately, most lawnmowers have two screws that allow you to adjust the carburetor yourself. … Then slowly adjust the screws tighter or looser in turn until the mower runs and idles smoothly.