You asked: What are three different types of inspections that should be accomplished when overhauling an engine?

There are 3 basic categories of inspection during overhaul: visual, structural non-destructive testing (NDT) and dimensional.

What inspection must be performed on an aircraft reciprocating engine if it has been operated on turbine fuel?

What inspection must be performed on an aircraft reciprocating engine if it has been operated on turbine fuel? The inside of the cylinders must be inspected with a borescope. The oil must be changed and the filters examined, and the engine given a careful run-up and operational check.

What inspections must be performed following a turbine engine overspeed?

Engine inspections 3

Question Answer
What inspections must be performed following a turbine engine overspeed? Refer to the engine manufacturer’s maintenance manual for the required procedures.
What inspections must be performed on a turbine engine if the exhaust gas temperature exceeds limitations? A hot section inspection.
THIS IS IMPORTANT:  What vehicles can go underwater?

What type of inspection would be a hot section inspection?

A hot section inspection (HSI) involves examining the condition of a number of key engine parts, including the turbine blades, the combustion chamber, the stators, the vane rings, the compressor turbine disk and the shroud segments. A hot section inspection is performed on a PT6 engine.

What are the three main sections of a gas turbine engine required for operation?

The combustion (gas) turbines being installed in many of today’s natural-gas-fueled power plants are complex machines, but they basically involve three main sections: The compressor, which draws air into the engine, pressurizes it, and feeds it to the combustion chamber at speeds of hundreds of miles per hour.

Where can the engine operating limitations be found?

(a) Engine ratings and operating limitations are established by the Administrator and included in the engine certificate data sheet specified in § 21.41 of this chapter, including ratings and limitations based on the operating conditions and information specified in this section, as applicable, and any other …

What FAR requires the 100-hour inspection of an aircraft engine?

100-hour inspections are required only on aircraft that carry persons for hire or are used to give flight instruction for hire.

What is the most common type of damage that is found in the hot section of a turbine engine?

7. What is the most common type of damage that is found in the hot section of a turbine engine? Cracks that are caused by the high concentration of heat in the hot section. 8.

THIS IS IMPORTANT:  Can you reuse car seat second child?

What are the two basic sections of a turbine engine?

What are the two basic sections of a turbine engine? The hot section and the cold section.

What means hot section?

That portion of the gas turbine engine that operates at high temperature. It includes all parts after the compressor (combustors, the turbine, and the exhaust system).

What is the first engine instrument indication of a successful start of a turbine engine?

A- double entry centrifugal compressor. 26 (8133) – What is the first engine instrument indication of a successful start of a turbine engine? C- A rise in the exhaust gas temperature.

What are the two main types of turbine compressor?

There are two basic types of compressors – axial flow and centrifugal flow.